Re: still not work ... Any other possible can help me???

[ Post a new reply ] [ Back to the message board ]

This message was posted by D, posted on March 02, 2001 at 02:55:51 coming from 216.66.143
This message is a reply to Re: Use an external power supply posted from The Dumper posted at March 01, 2001 at 11:52:46
> > > > Any can help me to fix the error? I already switch the new floppy drive but still got the error message!

> > > 9V DC center negative.

> > I am using Input 120V AV60Hz 20W; output 9V DC1.2A and I try 9V DC500mA
> > But still ...error message appear whenn it start!
> > Are you sure is poower problems?
> > I will try to get one 9V DC 850mA to have final test.

> I have seen many units with the same simptom and that was always the solution for me. The 9VDC 1.2A should be fine BUT you must make sure that the polarity is center negative. If it's center positive it's the same as not using a power supply at all (which doesn't help at all).

> Did you check that the cable going the floppy was plugged in properly? Does it work when you hold down the R button on controller one when you power up?

hi
I am using 10V 0.85A but still not work!! So disappointed!! I think it may not related to the power. I also replace the new floppy drive already.

It doesn't work when you hold down the R button on controller once when power up the system.

Responses to this messages:

Disk Error (WCM) for sure is related to power conflict !! D 13:16:45 03/03/01 (0) responses

Post a Followup

Name
E-Mail
Subject
Message	> > > > > Any can help me to fix the error? I already switch the new floppy drive but still got the error message! > > > > 9V DC center negative. > > > I am using Input 120V AV60Hz 20W; output 9V DC1.2A and I try 9V DC500mA > > > But still ...error message appear whenn it start! > > > Are you sure is poower problems? > > > I will try to get one 9V DC 850mA to have final test. > > I have seen many units with the same simptom and that was always the solution for me. The 9VDC 1.2A should be fine BUT you must make sure that the polarity is center negative. If it's center positive it's the same as not using a power supply at all (which doesn't help at all). > > Did you check that the cable going the floppy was plugged in properly? Does it work when you hold down the R button on controller one when you power up? > hi > I am using 10V 0.85A but still not work!! So disappointed!! I think it may not related to the power. I also replace the new floppy drive already. > It doesn't work when you hold down the R button on controller once when power up the system.
Optional Link URL
Optional Link Title
Optional Image URL

Please pick a mood for your message:
Please pick a mood for your message: